DE-GermanEN/US-EnglishPL-PolishRU-Russian

Applicazioni SEVEN


Applicazioni con funzioni opzionali:
Prevenzione del colpo di ariete e riduzione della cavitazione

  • Attuatori multigiro 2SA7...
  • Attuatori angolari 2SQ7...

Funzioni - Caratteristiche

  • regolazione della velocità in funzione della corsa
    ⇒ fino a 10 differenti porzioni della corsa possono essere impostate a velocità differenti
  • regolazione dei tempi in funzione della corsa
    ⇒ indipendentemente per operazioni di CHISURA e APERTURA parti della corsa possono essere impostate per essere eseguite in tempi definiti - rendendo possibili anche tempi di posizionamento estremamente lunghi.
  • linearizzazione del flusso
  • modalità di funzionamento programmabile separatamente per operazioni di emergenza (ESD)
  • ridotto consumo elettrico (nessuna corrente di start-up)
  • In collegamento con UPS sono possibili operazioni anche in caso di mancanza di alimentazione.


ESD with UPS avoids water hammer

State Water Supplier - Landeswasserversorgung Stuttgart

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
453
kByte
  


SIPOS actuators with UPS
SIPOS Aktorik can provide single phase actuators (with 3-phase asynchronous motors) for standard and modulating duty. Low power consumption and proven reliability in the SIPOS actuator, combined with a single phase power supply, allows low cost UPS systems to be used in 230 V single phase systems: this ensures emergency operation in the event of a pipe break.
Additionally, mains water systems are protected against potentially damaging pressure surges (water hammer).

 

Avoiding water hammer
Carrum Ultrafiltration Plant, Australia

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
412
kByte
  


Surge prevention in ultrafiltration plant
SIPOS actuator in use at the Carrum Ultrafiltration Plant, a part of the Melbourne Metropolitan Water Purification System, where the actuator’s variable speed closure capability avoids problems associated with water hammer generated during valve shut-off.

 

Water hammer and cavitation protection
Oura Pumping Station, Australia

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
278
kByte
  


Water pumping from bore holes
water is pumped from a number of bore holes into a collection tank and then onto a holding tank. Three pumps are each equipped with 12” butterfly valves to control the water flow.


In order to protect the valve seats from damage caused by water cavitation, or the pumps from running dry in the event of water loss, the butterfly valves must be capable of rapid closure. Such operation creates huge hydraulic forces, known as water hammer. These forces are sufficient to cause significant pipework damage and must be avoided.

 

Druckstoßvermeidung in Colorado
ECCV Southern Booster Pumpstation, USA

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
389
kByte
  


Avoiding water hammer
The ECCV Southern Booster Pump Station in Colorado is fitted with high volume pumps and uses pump check valves for flow control.

To avoid water hammer and potentially serious system damage the application requires a linear flow characteristic.

The design challenge is obtaining linear flow from a ball valve which typically exhibits non-linear flow characteristics as it is closed/opened.

 

Water hammer prevention at sewage facility

Wyong Sewage pump station, Australia

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
231
kByte
  


Sewage pumping
Wyong ’s sewerage system consists of sewers, pumping stations and pump mains to transfer predominately liquid waste to the treatment works. Within the pumping stations, in addition to the dual pump system, sluice valves are used to control the flow of effluent.
Rapid closure of the pump discharge valve during normal operation will cause water hammer to occur. The hydraulic forces generated during rapid closure are sufficient to cause damage to pipework and therefore must be prevented. In addition, the installation of pump, pipework and valves underground means that access is limited.

 

Linear flow control from a non-linear valve
Kiva Pumpstation, Albuquerque, New Mexico, USA

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
318
kByte
  


Linear flow control with smooth pumping operation
Kiva Pumping Station, located in Albuquerque, New Mexico, is connected to an existing part of the water supply system, but has experienced growing demand and must significantly increase capacity.
The valve/actuator system must manage water surges during pump start-up and shut-down and provide linear water flow control during normal operation.
In addition, the use of advanced electrical design incorporating inverter technology allows the use of simple single phase UPS supplies to control the valve in event of power failure.

 

Linear flow control and emergency shut-off
North Water Reclamation Facility, Erie, Colorado, USA

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
321
kByte
  


Non-potable water pumping
The non-potable water pumping station located in Erie, Colorado distributes treated water from a storage reservoir to the town’s irrigation system and to Boulder Creek in the Rocky Mountains.
The valve / actuator system must manage water surges during pump start-up and shut-down, provide linear water flow control during normal operation and protect the pump in the event of power failure.
In addition, the use of advanced electrical design incorporating inverter technology allows the use of simple single phase UPS supplies to control the valve in event of power failure.

 

Enhanced valve control on water treatment network
Lower Molonglo WWTP network, Canberra, Australia

DE
Deutsch
02/13
EN/US
Englisch
02/13
RU
Russisch
02/13
249
kByte
  


Lower Molonglo waste water treatment plant
The Lower Molonglo treatment plant is situated close to Canberra in Eastern Australia and treats water from a wide catchment area.

An actuator on one of the remote network supply lines, located a 20 minute drive south of the treatment works, required replacing with a more sophisticated valve control.

 

Dati societari   Informativa privacy   Mappa del sito   Login   Indirizzi di contatto: Generale   Vendite   Assistenza